Huawei Quidway S6500 Series Operation Manual page 232

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
Refreshing BGP routes
6.2.1 Enabling BGP
To enable BGP, local AS number should be specified. After the enabling of BGP, local
router listens to BGP connection requests sent by adjacent routers. To make the local
router send BGP connection requests to adjacent routers, refer to the configuration of
the peer command. When BGP is disabled, all established BGP connections will be
disconnected.
Perform the following configurations in system view.
Table 6-1 Enabling/Disabling BGP
Enable BGP and enter the BGP view
Disable BGP
By default, BGP is not enabled.
6.2.2 Configuring basic features for BGP peer
Perform the following configurations in BGP view.
I. Creating a peer group
A BGP peer must belong to a peer group. Before configuring a BGP peer, a peer group
to which the peer belongs must be created first.
Table 6-2 Creating a peer group
Create a peer group
Delete a specified peer group
There are two types of BGP peer group, IBGP and EBGP. Using internal to create a
IBGP peer group. Using external to create a EBGP peer group and sub-AS peer
groups inside a confederation. group-name is locally significant.
The default type of BGP peer group is IBGP.
Operation
Operation
Huawei Technologies Proprietary
bgp as-number
undo bgp [ as-number ]
Command
group group-name [ internal | external ]
undo group group-name
6-5
Chapter 6 BGP Configuration
Command