Display And Debug Mstp - Huawei Quidway S6500 Series Operation Manual

Operation Manual - STP
Quidway S6500 Series Ethernet Switches
Table 1-27 Enable/Disable MSTP on a port
Enable MSTP on a port.
Disable MSTP on a port.
II. Configure in Ethernet port view
Perform the following configuration in Ethernet port view.
Table 1-28 Enable/Disable MSTP on a port
Enable MSTP on a port.
Disable MSTP on a port.
You can enable/disable MSTP on a port with either of the above-mentioned measures.
For more about the commands, refer to the Command Manual.
Note that redundant route may be generated after MSTP is disabled.
By default, MSTP is enabled on all the ports after it is enabled on the device.

1.3 Display and Debug MSTP

After the above configuration, execute display command in any view to display the
running of the MSTP configuration, and to verify the effect of the configuration. Execute
reset command in user view to clear the statistics of MSTP module. Execute
debugging command in user view to debug the MSTP module
Table 1-29 Display and Debug MSTP
Show the configuration information about
MSTP of the current device
Show the configuration information about the
current port and the switch.
Show the current configuration information of
the LPU board
Show the configuration information about the
region.
Clear the MSTP statistics information.
Operation
Operation
Operation
Huawei Technologies Proprietary
1-29
Chapter 1 MSTP Region-configuration
Command
stp interface interface-list enable
stp interface interface-list disable
Command
stp enable
stp disable
Command
display stp
display stp [ instance instance-id ]
[ interface interface-list | slot
slot-num ] [ brief ]
display stp slot number [ brief ]
display stp region-configuration
reset stp [ interface interface-list ]