Huawei Quidway S6500 Series Operation Manual page 119

Operation Manual - Network Protocol
Quidway S6500 Series Ethernet Switches
Table 7-1 Enable IPX
Enable IPX
Disable IPX
By default, IPX is disabled.
Note that after the undo ipx enable command is executed, the IPX configurations are
not recoverable with the ipx enable command.
7.2.2 Assign IPX Network Numbers to VLAN Interfaces
To have IPX enabled on a VLAN interface after it is enabled globally, you must assign a
network number to the VLAN interface. One VLAN interface can have only one network
number.
Perform the following configuration in VLAN interface view.
Table 7-2 Assign an IPX network number to VLAN interface
Assign an IPX network number to the
VLAN interface
Delete the IPX network number of the
VLAN interface
By default, no network number is assigned to the VLAN interface. In other words, IPX is
disabled on all the VLAN interface even after it is enabled globally.
Note that deleting the IPX network number of the VLAN interface also deletes the IPX
configuration and routing information on the interface.
7.2.3 Configure IPX Static Routes
Perform the following configuration in system view.
Table 7-3 Configure an IPX static route
Configure an IPX static route
Delete an IPX static route
Operation
Operation
Operation
Huawei Technologies Proprietary
ipx enable
undo ipx enable
ipx network network-number
undo ipx network
Command
ipx route-static
[ preference value ] [ tick ticks hop hops ]
undo ipx route-static { network [ network.node ] |
all }
7-3
Chapter 7 IPX Configuration
Command
Command
network network.node