Configuring Modem Attributes - Huawei Quidway S6500 Series Operation Manual

Operation Manual - Getting Started
Quidway S6500 Series Ethernet Switches
Table 4-17 Setting the command priority
Set the command priority in a specified
view.
Restore the default command level in a
specified view.
Note:
Please do not change the command level at will for it may cause inconvenience of
maintenance and operation.

4.2.6 Configuring Modem Attributes

When logging in the switch via the Modem, you can use the following commands to
configure these parameters.
Perform the following configurations in user interface (AUX user interface only) view.
Table 4-18 Configuring Modem Attributes
Set the interval since the system
receives the RING until CD_UP
Restore the default interval since the
system receives the RING until CD_UP
Configure auto answer
Configure manual answer
Configure to allow call-in
Configure to bar call-in
Configure to permit call-in and call-out.
Configure to disable call-in and call-out
4.2.7 Configuring Redirection
I. send command
The following command can be used for sending messages between user interfaces.
Perform the following configuration in user view.
Operation
Operation
Huawei Technologies Proprietary
4-10
Chapter 4 User Interface Configuration
Command
command-privilege level level view
view command
undo command-privilege view view
command
Command
modem timer answer seconds
undo modem timer answer
modem auto-answer
undo modem auto-answer
modem call-in
undo modem call-in
modem both
undo modem both