Huawei Quidway S6500 Series Operation Manual page 131

Operation Manual - Network Protocol
Quidway S6500 Series Ethernet Switches
# Configure a static route with the destination network number 3.
[Quidway-Vlan-interface1] quit
[Quidway] ipx route-static 3 1000.00e0-fc01-0001 tick 7 hop 2
2) Configure Switch B
# Enable IPX.
[Quidway] ipx enable
# Assign the network number 3 to VLAN interface 2 to enable IPX on the interface.
[Quidway] interface vlan-interface 2
[Quidway-Vlan-interface2] ipx network 3
# Set the IPX packet encapsulation format to Ethernet_SNAP on VLAN interface 2.
[Quidway-Vlan-interface2] ipx encapsulation snap
[Quidway-Vlan-interface2] quit
# Assign the network number 1000 to VLAN interface 1 to enable IPX on the interface.
[Quidway] interface vlan-interface 1
[Quidway-Vlan-interface1] ipx network 1000
# Configure a static route with the network number 2
[Quidway-Vlan-interface1] quit
[Quidway] ipx route-static 2 1000.00e0-fc01-0000 tick 7 hop 2
# Configure a service information entry, indicating that Server can provide the file
service.
[Quidway] ipx service 4 fileserver 2.0000-0c91-f61f 451 hop 2
# Configure a service information entry, indicating that Server can provide the print
service.
[Quidway] ipx service 7 tree 2.0000-0c91-f61f 5 hop 2
7.5 Troubleshoot IPX
I. Troubleshoot IPX forwarding
Fault 1: A destination address cannot be pinged.
Troubleshooting:
Check that the destination address is correct.
Execute the display ipx interface command; check that the network number and
IPX frame encapsulation format configured on the interface on the switch are
consistent with those configured on the connected interface.
Execute the display ipx routing-table command; check that the destination
network is reachable.
Huawei Technologies Proprietary
7-15
Chapter 7 IPX Configuration