Huawei Quidway S6500 Series Operation Manual page 199

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
[Switch B-ospf-1-area-0.0.0.0] network 196.1.1.0 0.0.0.255
[Switch B-ospf-1-area-0.0.0.0] quit
[Switch B-ospf-1] area 1
[Switch B-ospf-1-area-0.0.0.1] network 197.1.1.0 0.0.0.255
[Switch B-ospf-1-area-0.0.0.1] vlink-peer 3.3.3.3
# Configure Switch C:
[Switch C] interface Vlan-interface 1
[Switch C-Vlan-interface1] ip address 152.1.1.1 255.255.255.0
[Switch C] interface Vlan-interface 2
[Switch C-Vlan-interface2] ip address 197.1.1.1 255.255.255.0
[Switch C] router id 3.3.3.3
[Switch C] ospf
[Switch C-ospf-1] area 1
[Switch C-ospf-1-area-0.0.0.1] network 197.1.1.0 0.0.0.255
[Switch C-ospf-1-area-0.0.0.1] vlink-peer 2.2.2.2
[Switch C-ospf-1-area-0.0.0.1] quit
[Switch C-ospf-1] area 2
[Switch C-ospf-1-area-0.0.0.2] network 152.1.1.0 0.0.0.255
4.5 OSPF Fault Diagnosis and Troubleshooting
Fault 1: OSPF has been configured in accordance with the above-mentioned steps, but
OSPF on the router cannot run normally.
Troubleshooting: Please check according to the following procedure.
Troubleshooting locally: Check whether the protocol between two directly connected
routers is in normal operation. The normal sign is the peer state machine between the
two routers reaches the FULL state. (Note: On a broadcast or NBMA network, if the
interfaces for two routers are in DROther state, the peer state machine for the two
routers are in 2-way state, instead of FULL state. The peer state machine between
DR/BDR and all the other routers is in FULL state.
Execute the display ospf peer command to view peers.
Huawei Technologies Proprietary
4-31
Chapter 4 OSPF Configuration