Sending The Information To Loghost - Huawei Quidway S6500 Series Operation Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches
Table 4-19 Turn on/off the information synchronization switch in Fabric
Device
Switch

4.5.3 Sending the Information to Loghost

To send configuration information to loghost, follow the steps below:
1) Enabling info-center
Perform the following operation in system view.
Table 4-20 Enable/disable info-center
Enable info-center
Disable info-center
Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2) Configuring to output information to loghost
Perform the following operation in system view.
Configuration
Enable By default, info-center
info-center is enabled.
By default, switches of
master log in Fabric,
debugging
Set the
information
information synchronization
output direction turned on, so as log
to SNMP and strap information
synchronization
switches
switches.
Operation
Huawei Technologies Proprietary
4-14
Chapter 4 System Maintenance and Debugging
Default value
Other configurations are
valid only if the info-center
is enabled.
and trap
This
keep
are
debugging information and
trap information in Fabric in
every switch synchronized.
in other
info-center enable
undo info-center enable
Configuration
description
configuration
log information,
Command
can