Huawei Quidway S6500 Series Operation Manual page 416

Operation Manual - STP
Quidway S6500 Series Ethernet Switches
Table 1-21 Configure the port (not) to connect with the point-to-point link
Configure the port to connect with the
point-to-point link.
Configure the port not to connect with the
point-to-point link.
Configure MSTP to automatically detect if the
port is
point-to-point link.
Configure MSTP to automatically detect if the
port is
point-to-point link, as defaulted.
II. Configure in Ethernet port view
Perform the following configuration in Ethernet port view.
Table 1-22 Configure the port (not) to connect with the point-to-point link
Configure the port to connect with the point-to-point
link.
Configure the port not to connect with the point-to-point
link.
Configure MSTP to automatically detect if the port is
directly connected with the point-to-point link.
Configure MSTP to automatically detect if the port is
directly connected with the point-to-point link, as
defaulted.
You can configure the port (not) to connect with the point-to-point link with either of the
above-mentioned measures. For more about the commands, refer to the Command
Manual.
For the ports connected with the point-to-point link, upon some port role conditions met,
they can transit to forwarding state fast through transmitting synchronization packet,
thereby reducing the unnecessary forwarding delay. If the parameter is configured as
auto mode, MSTP will automatically detect if the current Ethernet port is connected with
the point-to-point link.
Operation
directly connected
directly connected
Operation
Huawei Technologies Proprietary
Chapter 1 MSTP Region-configuration
stp
point-to-point force-true
stp
point-to-point force-false
stp
with the
point-to-point auto
undo stp interface interface-list
with the
point-to-point
1-24
Command
interface interface-list
interface interface-list
interface interface-list
Command
stp point-to-point
force-true
stp point-to-point
force-false
stp point-to-point auto
undo stp point-to-point