Configure The Max Transmission Speed On A Port - Huawei Quidway S6500 Series Operation Manual

Operation Manual - STP
Quidway S6500 Series Ethernet Switches
You are recommended to use the stp root primary command to specify the network
diameter and Hello Time of the switching network, thus MSTP will automatically
calculate and give the rather desirable values.
By default, Forward Delay is 15 seconds, Hello Time is 2 seconds, and Max Age is 20
seconds.

1.2.9 Configure the Max Transmission Speed on a Port

The max transmission speed on a port specifies how many MSTP packets will be
transmitted every Hello Time via the port.
The max transmission speed on a port is limited by the physical state of the port and the
network structure. You can configure it according the network conditions.
You can configure the max transmission speed on a port in the following ways.
I. Configure in system view
Perform the following configuration in system view.
Table 1-11 Configure the max transmission speed on a port
Configure the max transmission speed
on a port.
Restore the max transmission speed on
a port.
II. Configure in Ethernet port view
Perform the following configuration in Ethernet port view.
Table 1-12 Configure the max transmission speed on a port
Configure the max transmission speed
on a port.
Restore the max transmission speed on
a port.
You can configure the max transmission speed on a port with either of the
above-mentioned measures. For more about the commands, refer to the Command
Manual.
This parameter only takes a relative value without units. If it is set too large, too many
packets will be transmitted during every Hello Time and too many network resourced
will be occupied. The default value is recommended.
Operation
Operation
Huawei Technologies Proprietary
1-18
Chapter 1 MSTP Region-configuration
Command
stp interface
transmit-limit packetnum
undo stp interface
transmit-limit
Command
stp transmit-limit packetnum
undo stp transmit-limit
interface-list
interface-list