Setting The Supported Type Of The Radius Server; Setting The Radius Server State - Huawei Quidway S6500 Series Operation Manual

Operation Manual - Security
Quidway S6500 Series Ethernet Switches
II. Configuration preparations
Create the RADIUS scheme and configure the RADIUS authentication/accounting
server in the scheme as CAMS.
III. Configuration tasks
The following table describes the user Re-authentication at reboot configuration tasks.
Table 2-25 User Re-authentication at reboot configuration
Enter system view
Enter RADIUS scheme view
Enable user re-authentication
at reboot

2.3.7 Setting the Supported Type of the RADIUS Server

Quidway Series Ethernet Switches support the standard RADIUS protocol and the
extended RADIUS service platforms developed by Huawei.
You can use the following command to set the supported types of RADIUS servers.
Perform the following configurations in RADIUS scheme view.
Table 2-26 Setting the supported type of the RADIUS server
Setting the Supported Type of RADIUS
Server
Restore the RADIUS server type to the
default setting
By default, the newly created RADIUS scheme supports the server of standard type,
while the "system" RADIUS scheme created by the system supports the server of
huawei type.

2.3.8 Setting the RADIUS Server State

For the primary and second servers (no matter it is an authentication/authorization
server or accounting server), if the primary is disconnected to NAS for some fault, NAS
will automatically turn to exchange packets with the second server. However, after the
primary one recovers, NAS will not resume the communication with it at once, instead,
it continues communicating with the second one. When the second one fails to
Item
system-view
radius
radius-scheme-name
accounting-on enable
Operation
Huawei Technologies Proprietary
2-20
Chapter 2 AAA and RADIUS Protocol
Command
––
scheme
––
By default, this feature
is not enabled.
Command
server-type { huawei | standard }
undo server-type
Configuration
Description