Queue Traffic Monitoring Configuration Example; Configuring Error Packets Monitoring; Error Packets Monitoring Configuration Task - Huawei Quidway S6500 Series Operation Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches
Table 3-13 Configure queue traffic monitoring
Number
1
2
3
To cancel the related configuration, use the qe monitor disable command.

3.6.2 Queue Traffic Monitoring Configuration Example

I. Network requirements
Enable queue traffic monitoring.
Set the overall traffic threshold used in queue traffic monitoring to 90 Mbps.
II. Configuration procedure
1) Enter system view.
<Quidway> system-view
[Quidway]
2) Enable queue traffic monitoring.
[Quidway] qe monitor enable
3) Set the overall traffic threshold used in queue traffic monitoring to 90 Mbps.
[Quidway] qe monitor overflow-threshold 90000000

3.7 Configuring Error Packets Monitoring

If the switch receives a great number of error packets, it will not be able to send/receive
packets properly. With error packets monitoring enabled, the switch collects information
about received error packets regularly. If error packets are detected, it takes protection
measures to ensure that its interfaces send/receive packets properly.

3.7.1 Error Packets Monitoring Configuration Task

The following describes configuration tasks of error packets monitoring.
Operation
Enter system view <Quidway> system-view
Enable queue [Quidway] qe monitor
traffic monitoring enable
[Quidway] qe monitor
Set the overall
overflow-threshold
traffic threshold
threshold
Huawei Technologies Proprietary
Command
3-10
Chapter 3 Device management
Remarks
–
Required.
function is enabled by
default.
Optional. Defaults to
50,000,000 bps.
This