Huawei Quidway S6500 Series Operation Manual page 557

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches
Table 4-16 Sending the Information to log buffer
Device
Switch
6) Sending the Information to trap buffer.
Table 4-17 Sending the Information to trap buffer
Device
Switch
7) Sending the Information to SNMP
Configuration
Enable info-center
Set the information
output direction to
logbuffer
Set information
source
Configuration
Enable info-center
Set the information
output direction to
trapbuffer
Set information
source
Huawei Technologies Proprietary
4-12
Chapter 4 System Maintenance and Debugging
Default value
By default, Other configurations are
info-center is valid only if the info-center
enabled. is enabled.
You can configure the size
- of the log buffer at the same
time.
You
modules and information to
be
time-stamp
- information, and so on. You
must turn on the switch of
the corresponding module
before
debugging information.
Default value
By default, Other configurations are
info-center is valid only if the info-center
enabled. is enabled.
You can configure the size
- of the trap buffer at the
same time.
You
modules and information to
be
time-stamp
information, and so on.
-
You must turn on the
switch
corresponding
before
debugging information.
Configuration
description
can define which
sent out and the
format of
defining output
Configuration
description
can define which
sent out and the
format of
of the
module
defining output