Huawei Quidway S6500 Series Operation Manual page 173

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
Configuring the Cost for Sending Packets on an Interface
Setting the Interface Priority for DR Election
Setting the peer
Setting the Interval of Hello Packet Transmission
Setting a dead timer for the neighboring routers
Configuring an Interval required for sending LSU packets
Setting an Interval for LSA Retransmission between Neighboring Routers
Setting a Shortest Path First (SPF) Calculation Interval for OSPF
Configuring STUB Area of OSPF
Configuring NSSA of OSPF
Configuring the Route Summarization of OSPF Area
Configuring OSPF Area Route Summary
Configuring OSPF Virtual Link
Configuring Summarization of Imported Routes by OSPF
Configuring the OSPF Area to Support Packet Authentication
Configuring OSPF Packet Authentication
Configuring OSPF to import Routes of Other Protocols
Configuring Parameters for OSPF to Import External Routes
Configuring OSPF to Import the Default Route
Setting OSPF Route Preference
Configuring OSPF Route Filtering
Configuring to Fill the MTU Field When an Interface Transmits DD Packets
Disabling the Interface to Send OSPF Packets
Configuring OSPF and Network Management System
Resetting the OSPF Process
4.2.1 Enabling OSPF and Enter OSPF View
Perform the following configurations in system view.
Table 4-1 Enabling OSPF process
Enable OSPF process
Disable the OSPF process
By default, OSPF is not enabled.
When enabling OSPF, pay attention to the following points:
By default, the OSPF process ID is 1.
If a router is running multiple OSPF processes, you are recommended to use
router-id in the command to specify different Router IDs for different processes.
Operation
Huawei Technologies Proprietary
4-5
Chapter 4 OSPF Configuration
Command
ospf [ process-id [ router-id router-id ] ]
undo ospf [ process-id ]