Displaying And Debugging 802.1X; Configuration Example - Huawei Quidway S6500 Series Operation Manual

Operation Manual - Security
Quidway S6500 Series Ethernet Switches
Table 1-16 Enabling/disabling a quiet-period timer
Enable a quiet-period timer
Disable a quiet-period timer
By default, quiet-period timer is disabled.

1.3 Displaying and Debugging 802.1x

After the above configuration, execute display command in any view to display the
running of the VLAN configuration, and to verify the effect of the configuration. Execute
reset command in user view to reset 802.1x statistics. Execute debugging command
in user view to debug 802.1x.
Table 1-17 Displaying and debugging 802.1x
Display the configuration, running
and statistics
802.1x
Reset
information
Enable the error/event/packet/all
debugging of 802.1x
Disable the error/event/packet/all
debugging of 802.1x.
1.4 802.1x Configuration Example
I. Networking requirements
As shown in the following figure, the workstation of a user is connected to the port
Ethernet 3/0/1 of the Switch.
The switch administrator will enable 802.1x on all the ports to authenticate the
supplicants so as to control their access to the Internet. The access control mode is
configured as based on the MAC address
All the supplicants belong to the default domain huawei163.net, which can contain up to
30 users. RADIUS authentication is performed first. If there is no response from the
RADIUS server, local authentication will be performed. For accounting, if the RADIUS
server fails to account, the user will be disconnected. In addition, when the user is
Operation
Operation
information
the 802.1x statistics
Huawei Technologies Proprietary
dot1x quiet-period
undo dot1x quiet-period
display dot1x [ sessions | statistics ]
of
[ interface interface-list ]
reset dot1x
interface-list ]
debugging dot1x { error | event | packet |
all }
undo debugging dot1x { error | event |
packet | all }
1-13
Chapter 1 802.1x Configuration
Command
Command
[
statistics interface