Display And Debug Snmp; Snmp Configuration Example - Huawei Quidway S6500 Series Operation Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches

5.4 Display and Debug SNMP

After the above configuration, execute display command in any view to display the
running of the SNMP configuration, and to verify the effect of the configuration. Execute
debugging command in user view to debug SNMP configuration.
Table 5-16 Display and debug SNMP
Display
information
packets
Display the engine ID of the
active device
Display the group name, the
security mode, the states for all
types of views, and the storage
mode of each group of the
switch.
Display the names of all users
in the group user table
Display the current community
name
Display the current MIB view
Display the contact character
string of the system
Display the location character
string of the system
Display the version character
string of the system

5.5 SNMP Configuration Example

I. Networking requirements
Network Management Station and the Ethernet switch are connected via the Ethernet.
The IP address of Network Management Station is 129.102.149.23 and that of the
VLAN interface on the switch is 129.102.0.1. Perform the following configurations on
the switch: setting the community name and access authority, administrator ID, contact
and switch location, and enabling the switch to sent trap packet.
Operation
the statistics
about SNMP
Huawei Technologies Proprietary
Command
display snmp-agent statistics
display snmp-agent
remote-engineid }
display snmp-agent group [ group-name ]
display snmp-agent
engineid ] [ group groupname ] [ username
username ]
display snmp-agent community [ read | write ]
display snmp-agent mib-view [ exclude |
include | { viewname mib-view } ]
display snmp-agent sys-info contact
display snmp-agent sys-info location
display snmp-agent sys-info version
5-9
Chapter 5 SNMP Configuration
{ local-engineid
usm-user [ engineid
|