Set Ntp Authentication Key; Set Specified Key As Reliable; Designate An Interface To Transmit Ntp Message - Huawei Quidway S6500 Series Operation Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches
Table 7-7 Configure NTP authentication
Enable NTP authentication
Disable NTP authentication

7.2.3 Set NTP Authentication Key

This configuration task is to set NTP authentication key.
Perform the following configurations in system view.
Table 7-8 Configure NTP authentication key
Configure NTP authentication key
Remove NTP authentication key
Key number number ranges from 1 to 4294967295; the key value contains 1 to 32
ASCII characters.

7.2.4 Set Specified Key as Reliable

This configuration task is to set the specified key as reliable.
Perform the following configurations in system view.
Table 7-9 Set the specified key as reliable
Set the specified key as reliable
Cancel the specified reliable key.
Key number key-number ranges from 1 to 4294967295

7.2.5 Designate an Interface to Transmit NTP Message

If the local equipment is configured to transmit all the NTP messages, these packets
will have the same source IP address, which is taken from the IP address of the
designated interface.
Operation
Operation
Operation
Huawei Technologies Proprietary
Command
ntp-service authentication enable
undo ntp-service authentication enable
Command
ntp-service authentication-keyid
authentication-mode md5 value
undo ntp-service
number
Command
ntp-service reliable
key-number
undo ntp-service
authentication-keyid key-number
7-7
Chapter 7 NTP Configuration
number
authentication-keyid
authentication-keyid
reliable