Huawei Quidway S6500 Series Operation Manual page 76

Operation Manual - VLAN
Quidway S6500 Series Ethernet Switches
Note that you must add the card port where the protocol is to be applied to the
protocol-based VLAN. Currently, only the cards (include LPU and SRPU) except A type
ones support the command.
For the relationship between the card and the command ,see Table 1-12.
Table 1-12 The relationship between the card and the command
Command description
Create the association between a
card and a specific protocol-based
VLAN in system view
Create the association between an
port and a protocol-based VLAN in
Ethernet port view
Note:
A type card includes LS81FT48A, LS81FM24A, LS81FS24A, LS81GB8UA,
LS81GT8UA, iSalience I, Salience I and Salience II cards.
The cards except A type ones do not include LS81VSNP, LS81PT8GA and
LS81PT4GA.
1.5 Display and Debug VLAN
After the above configuration, execute display command in any view to display the
running of the VLAN configuration, and to verify the effect of the configuration.
Table 1-13 Display and debug VLAN
Display the related information
about VLAN interface
Display the related information
about VLAN
Display the protocol information
and protocol index configured
on the specified VLAN
Display the protocol information
and protocol index configured
on the specified port
Operation
Huawei Technologies Proprietary
A type card
not support
support
Command
display interface vlan-interface [ vlan-id ]
display vlan [ vlan-id [ to vlan-id ] | all | static |
dynamic ]
display protocol-vlan vlan { vlan-id [ to vlan-id ]
| all }
display protocol-vlan
{ { interface-type
interface-name }
interface-num | interface-name } ] | all }
1-8
Chapter 1 VLAN Configuration
Card except A type one
support ( only for all IP
protocol and subnet IP
protocol)
support ( not include all IP
protocol and subnet IP
protocol)
interface
interface-number
[ to { interface-type
|