Huawei Quidway S6500 Series Operation Manual page 115

Operation Manual - Network Protocol
Quidway S6500 Series Ethernet Switches
Table 6-3 Configure Whether to Forward L3 Broadcast Packets
Configure forward L3 broadcast packets
Disable forward L3 broadcast packets
By default, L3 broadcast packets is forwarded.
6.2 Display and debug IP Performance
After the above configuration, execute display command in any view to display the
running of the IP Performance configuration, and to verify the effect of the configuration.
Execute reset command in user view to clear IP, TCP and UDP statistics information.
Table 6-4 Display and debug IP performance
Display TCP connection state
Display TCP connection statistics data
Display UDP statistics information
Display IP statistics information
Display ICMP statistics information
Display socket interface information of
current system
Display the summary of the Forwarding
Information Base
Reset IP statistics information
Reset TCP statistics information
Reset UDP statistics information
6.3 Troubleshoot IP Performance
Fault: IP layer protocol works normally but TCP and UDP cannot work normally.
In the event of such a fault, you can enable the corresponding debugging information
output to view the debugging information.
Use the terminal debugging command to output the debugging information to
the console.
Use the command debugging udp packet to enable the UDP debugging to trace
the UDP packet.
Operation
Operation
Huawei Technologies Proprietary
6-3
Chapter 6 IP Performance Configuration
Command
ip forward-broadcast
undo ip forward-broadcast
Command
display tcp status
display tcp statistics
display udp statistics
display ip statistics
display icmp statistics
display ip socket
sock-type ] [ task-id socket-id ]
display fib
reset ip statistics
reset tcp statistics
reset udp statistics
[ socktype