Setting Traffic Limit - Huawei Quidway S6500 Series Operation Manual

Operation Manual - QoS/ACL
Quidway S6500 Series Ethernet Switches

2.2.5 Setting Traffic Limit

Traffic limit refers to rate limit based on traffic. If the traffic threshold is exceeded,
corresponding measures will be taken, for example, dropping the excessive packets or
re-defining their priority levels.
I. Configuration on A Type Card
Table 2-12 Configure traffic policing
Operation
Enter system
view
Enable
inbound car
Exit to user
view
Reboot
switch
Enter system
view
Configure
time range
Set the traffic
classification
mode for the
switch
Command
system-view
inboundcar enable
quit
the
reboot
system-view
time-range
{ start-time to end-time
days-of-the-week
start-time start-date ] [ to
end-time end-date ] | from
start-time start-date [ to
end-time end-date ] }
acl mode { ip-based |
link-based }
Huawei Technologies Proprietary
—
Optional.
You can enable or disable the
inbound car as needed.
By default, the inbound car is
disabled.
—
Optional.
You must reboot the switch to make
the inbound car settings take effect.
—
time-name
You must define the time range first
[ from
if you need to specify the time for the
ACL to take effect when defining the
ACL.
By default, the switch performs the
IP-based traffic classification.
ip-based: Performs the IP-based
traffic classification.
link-based: Performs the link-based
traffic classification.
2-13
Chapter 2 QoS Configuration
Remarks