Huawei Quidway S6500 Series Operation Manual page 164

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
Set the additional routing metric of the route
when the interface sends an RIP packet
Disable the additional routing metric of the
route when the interface sends an RIP packet
By default, the additional routing metric added to the route when RIP sends the packet
is 1. The additional routing metric when RIP receives the packet is 0 by default.
Note:
The metricout configuration takes effect only on the RIP routes learnt by the router and
RIP routes generated by the router itself, which means that it has no effect on the
routes imported to RIP by other routing protocols.
3.2.16 Configuring Route Filtering
The router provides the route filtering function. You can configure the filter policy rules
through specifying the ACL and ip-prefix for route redistribution and distribution.
Besides, to import a route, the RIP packet of a specific router can also be received by
designating a neighbor router.
Perform the following configurations in RIP view.
I. Configuring filtering the route received by RIP
Table 3-16 Configuring RIP to filter the received routes
Configure filtering the received routing
information distributed by the specified
address
Cancel filtering the received routing
information distributed by the specified
address
Configure filtering the received global
routing information
Operation
Operation
Huawei Technologies Proprietary
3-11
Chapter 3 RIP Configuration
Command
rip metricout value
undo rip metricout
Command
filter-policy gateway ip-prefix-name
import
undo filter-policy
ip-prefix-name import
filter-policy { acl-number | ip-prefix
ip-prefix-name
ip-prefix-name ]
route-policy-name } import
gateway
[ gateway
| route-policy