Huawei Quidway S6500 Series Operation Manual page 238

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
VIII. Specifying the source interface of a route update packet
Generally, the system specified the source interface of a route update packet. When
the interface fails to work, in order to keep the TCP connection valid, the interior BGP
session can be configured to specify the source interface. This command is usually
used the Loopback interface.
Table 6-16 Specifying the source interface of a route update packet
Specify the source interface of a route
update packet
Use the best source interface
By default, BGP carries out TCP connection with the optimal source interface.
IX. Configuring BGP MD5 authentification password
BGP uses TCP as its transport layer. For the sake of high security, you can configure
MD5 authentication password when setting up TCP connection. In other words, BGP
MD5 authentication just sets password for TCP connection, but not for authenticating
BGP packets. The authentication is implemented by TCP.
Please perform the following configurations in BGP view.
Table 6-17 Configuring BGP MD5 authentication
Configure MD5 authentication password
Cancel MD5 authentication
In BGP, no MD5 authentication is performed in setting up TCP connections by default.
6.2.4 Configuring route filtering of peer (group)
Quidway S6500 series switches support filtering imported and advertised routes for
peers (groups) through Route-policy, AS path list , ACL and ip prefix list.
Operation
Operation
Huawei Technologies Proprietary
6-11
Chapter 6 BGP Configuration
Command
peer { peer-address | group-name }
connect-interface
interface-name
undo peer {
group-name } connect-interface
interface-type interface-name
Command
peer { group-name | peer-address }
password { cipher | simple } password
undo peer {
peer-address } password
interface-type
peer-address |
group-name |