Huawei Quidway S6500 Series Operation Manual page 235

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
By default, the keep-alive message is sent every 60 seconds and the value of the hold
timer is 180 seconds.
VII. Configuring the interval at which route update messages are sent by a
peer group
Table 6-8 Configuring the interval at which route update messages are sent by a peer
group
Configure the route update message
interval of a peer group
Restore
message interval of a peer group
By default, the intervals at which route update messages are sent by an IBGP and
EBGP peer group are 5 seconds and 30 seconds respectively.
6.2.3 Configuring application features of BGP peer (group)
I. Configuring to Permit Connections with EBGP Peer groups on Indirectly
Connected Networks
Generally, EBGP peers must be connected physically. Otherwise the command below
can be used to perform the configuration in order to make them communicate with each
other normally.
Table 6-9 Configuring to permit connections with EBGP peer groups on indirectly
connected networks
Configure to permit connections with
EBGP
connected networks
Configure to permit connections with
EBGP
connected network only.
By default, only the connections with EBGP peer groups on directly connected
networks are permitted. ttl refers to time-to-live in the range of 1 to 255 with the default
value as 64.
Operation
the default route
Operation
peer groups on
peer groups on
Huawei Technologies Proprietary
peer
route-update-interval seconds
update undo
route-update-interval
indirectly peer group-name ebgp-max-hop [ ttl ]
directly undo peer group-name ebgp-max-hop
6-8
Chapter 6 BGP Configuration
Command
group-name
peer group-name
Command