Set The Processing Method For The Specific Packets; Display Mac Address Table; Mac Address Table Management Configuration Example - Huawei Quidway S6500 Series Operation Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches

2.2.4 Set the processing method for the specific packets

You can use the following commands to configure whether or not the packets with
destination MAC addresses being bridge MAC address of the switch are passed to
CPU for being processed.
Perform the following configuration in system view.
Table 2-4 Set the processing method for the specific packets
Configure the packets with destination MAC
addresses being bridge MAC address to be passed
to CPU for being processed.
Configure the packets with destination MAC
addresses being bridge MAC address not to be
passed to CPU
By default, the packets with destination MAC addresses being bridge MAC address are
not to be passed to CPU for being processed.

2.3 Display MAC Address Table

After the above configuration, execute display command in any view to display the
running of the MAC address table configuration, and to verify the effect of the
configuration.
Execute debugging command in user view to debug MAC address table configuration.
Table 2-5 Display and debug MAC address table
Display the information in the
address table
Display
dynamic address table entries

2.4 MAC Address Table Management Configuration Example

I. Networking requirements
The user logs in the switch via the Console port to configure the address table
management. It is required to set the address aging time to 500s and add a static
address 00e0-fc35-dc71 to Ethernet1/0/2 in vlan1.
Operation
Operation
the aging time of
Huawei Technologies Proprietary
Chapter 2 MAC Address Table Management
bridgemactocpu enable
bridgemactocpu disable
Command
display mac-address [ mac-addr [ vlan vlan-id ]
| [ static | dynamic ] [ interface { interface-name
| interface-type interface-num } ] [ vlan vlan-id ]
[ count ] ]
display mac-address aging-time
2-4
Command