Huawei Quidway S6500 Series Operation Manual page 270

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
Match the routing cost of the routing
information
Cancel the matched routing cost of the
routing information
Match the tag domain of the OSPF
routing information
Cancel the tag domain of the matched
OSPF routing information
By default, no matching will be performed.
But please note:
The if-match clauses for a node in the route-policy have the relationship of "AND"
for matching. That is, the route must satisfy all the clauses to match the node
before the actions specified by the apply clauses can be executed.
If no if-match clauses are specified, all the routes will pass the filtering on the node.
7.2.3 Defining apply clauses for a Route-policy
The apply clauses specify actions, which are the configuration commands executed
after a route satisfies the filtering conditions specified by the if-match clauses. Thereby,
some attributes of the route can be modified.
Perform the following configurations in Route policy view.
Table 7-3 Defining apply clauses
Add the specified AS number before the
as-path series of the BGP routing
information
Cancel the specified AS number added
before the as-path series of the BGP
routing information
Set the community attribute in the BGP
routing information
Cancel the set community attribute in the
BGP routing information
Set the next-hop address of the routing
information
Operation
Operation
Huawei Technologies Proprietary
7-5
Chapter 7 IP Routing Policy Configuration
Command
if-match cost value
undo if-match cost
if-match tag value
undo if-match tag
Command
apply as-path
[ as-number-2 [ as-number-3 ... ] ]
undo apply as-path
apply community { [ { aa:nn |
no-export-subconfed | no-advertise |
no-export ]... } | [ additive | none ]
undo apply community
apply ip next-hop ip-address
as-number-1