Display And Debug Acl - Huawei Quidway S6500 Series Operation Manual

Operation Manual - QoS/ACL
Quidway S6500 Series Ethernet Switches
Note:
Combined activating of IP ACL and Link ACL is supported by the cards except A type
ones. But the sum of the bytes number defined by IP ACL and that defined by the Link
ACL can not exceed 32 bytes; otherwise the ACL can not be activated.
Note:
ARP packets are always permitted passing through S6500 series switches. User can't
use packet-filter command to filter the ARP packets. That is, if defining a Link ACL with
the parameter protocol-type as ARP, it will not be effective when activating the Link
ACL by packet-filter command.

1.2.5 Display and Debug ACL

After the above configuration, execute display command in any view to display the
running of the ACL configuration, and to verify the effect of the configuration. Execute
reset command in user view to clear the statistics of the ACL module.
Table 1-11 Display and Debug ACL
Display the status of the time range
Display the detail information about the
ACL
Display the ACL mode chosen by the
switch
Display the information about the ACL
running state
Clear ACL counters
The matched information of display acl config command specifies the rules treated by
the switch's CPU. The matched information of the transmitted data by switch can be
displayed by display qos-interface traffic-statistic command.
For syntax description, refer to the Command Manual.
Operation
Huawei Technologies Proprietary
1-11
Chapter 1 ACL Configuration
Command
display time-range { all | name }
display acl config { all | acl-number |
acl-name }
display acl mode
display acl running-packet-filter { all |
interface { interface-name
interface-type interface-num } }
reset acl counter { all | acl-number |
acl-name }
|