Huawei Quidway S6500 Series Operation Manual page 261

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
6.4.3 Configuring BGP Routing
I. Networking requirements
This example illustrates how the administrators manage the routing via BGP attributes.
All Ethernet switches are configured with BGP, and IGP in AS 200 utilizes OSPF.
Switch A is in AS 100, and acts as Switch B of AS 200 and BGP neighbor of Switch C.
Switch B, Switch C and Switch D operate IBGP. Switch D is also in AS 200.
II. Networking diagram
1.1.1.1
To network
1.0.0.0
AS100
Figure 6-4 Networking diagram of configuring BGP routing
III. Configuration procedure
1) Configure Switch A:
[Switch A] interface Vlan-interface 2
[Switch A-Vlan-interface2] ip address 192.1.1.1 255.255.255.0
[Switch A] interface Vlan-interface 3
[Switch A-Vlan-interface3] ip address 193.1.1.1 255.255.255.0
# Enable BGP
[Switch A] bgp 100
# Specify the network that BGP sends to
[Switch A-bgp] network 1.0.0.0
# Configure the peers
[Switch A-bgp] group ex192 external
192.1.1.2/24
VLAN 2
192.1.1.1/24
Switch A EBGP
EBGP
VLAN 3
193.1.1.1/24
193.1.1.2/24
Huawei Technologies Proprietary
To network
2.2.2.2
2.0.0.0
VLAN 2
VLAN 4
194.1.1.2/24
Switch B
IBGP
Switch D
IBGP
Switch C
VLAN 5
VLAN 3
195.1.1.2/24
3.3.3.3
To network
3.0.0.0
6-34
Chapter 6 BGP Configuration
AS200
VLAN 4
194.1.1.1/24
4.4.4.4
VLAN 5
195.1.1.1/24
To network
4.0.0.0