Adding/Deleting A Virtual Ip Address - Huawei Quidway S6500 Series Operation Manual

Operation Manual - Reliability
Quidway S6500 Series Ethernet Switches
Table 1-2 Set correspondence between virtual IP address and MAC address
Set correspondence between the virtual
IP address and the MAC address
Set the correspondence to the default
value
By default, the virtual IP address of the backup group corresponds to the virtual MAC
address.
You must set correspondence between the virtual IP address of the backup group and
the MAC address before configuring the backup group. Otherwise, you cannot
configure the correspondence.
If the virtual MAC address using the routing interface of the switch matches with the
virtual IP address of the virtual router, only one virtual router can be configured on the
VLAN interface.

1.2.3 Adding/Deleting a Virtual IP Address

This operation assigns an IP address to a virtual router or removes an assigned
virtual IP address of a virtual router from the virtual address list.
Perform the following configuration in VLAN interface view.
Table 1-3 Add/delete a virtual IP address
Add a virtual IP address
Delete a virtual IP address
The virtual-router-ID ranges from 1 to 255. The virtual-address can be an unused
address in the network segment where the virtual router resides, or the IP address of
an interface in the virtual router. If the IP address is of the switch, it can also be
configured. In this case, the switch will be called an IP Address Owner. When
specifying the first IP address to a virtual router, the system will create a new virtual
router accordingly. When adding new address to this backup group thereafter, the
system will directly add it into the virtual IP address list.
Operation
Operation
Huawei Technologies Proprietary
vrrp method { real-mac | virtual-mac }
undo vrrp method
Command
vrrp vrid virtual-router-ID virtual-ip virtual-address
undo vrrp vrid
virtual-address ]
1-4
Chapter 1 VRRP Configuration
Command
virtual-router-ID [ virtual-ip