Huawei Quidway S6500 Series Operation Manual page 569

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches
Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2) Configuring to output information to trap buffer
Perform the following operation in system view.
Table 4-39 Configuring to output information to trap buffer
Output information to trap buffer
Cancel the configuration of outputting
information to trap buffer
3) Configuring information source on the switch
By this configuration, you can define the information that sent to trap buffer is generated
by which modules, information type, information level, and so on.
Perform the following operation in system view:
Table 4-40 Defining information source
Define information source
Cancel the configuration
of information source
modu-name specifies the module name; default represents all the modules; level
refers to the severity levels; severity specifies the severity level of information. The
information with the level below it will not be output. channel-number specifies the
channel number and channel-name specifies the channel name.
When defining the information sent to trap buffer, channel-number or channel-name
must be set to the channel that corresponds to Console direction.
Every channel has been set with a default record, whose module name is default and
the module number is 0xffff0000. However, for different channels, the default record
Operation
Operation
info-center source { modu-name | default } channel
{ channel-number | channel-name } [ { log | trap |
debug }* { level severity | state state }* ]
undo info-center source { modu-name | default }
channel { channel-number | channel-name }
Huawei Technologies Proprietary
Chapter 4 System Maintenance and Debugging
info-center trapbuffer [ size buffersize ]
[ channel
channel-name } ]
undo info-center trapbuffer [ channel |
size ]
Command
4-24
Command
{ channel-number |