Huawei Quidway S6500 Series Operation Manual page 127

Operation Manual - Network Protocol
Quidway S6500 Series Ethernet Switches
Table 7-19 Configure the maximum length of the service information reserve-queue for
one service type
Configure the maximum length of the
service information reserve-queue for
one service type.
Restore the default maximum length of
the service information reserve-queue
for one service type.
By default, the maximum length of the service information reserve-queue for one
service type is 2048.
If the length of the service information reserve-queue that you configure is less than the
original one, the current service entries are not deleted. And if the number of the
service entries of the same type reaches the specified value, new service information is
not added.
7.2.7 Configure Triggered Update in IPX
IPX RIP and SAP periodically broadcast update. If the periodical broadcast is not
desired, you can enable triggered update on the VLAN interfaces on the switch. This
allows the switch to broadcast update only when route or service information changes,
thus avoiding broadcast flooding.
Perform the following configuration in VLAN interface view.
Table 7-20 Configure triggered update of IPX
Enable triggered update of IPX
Disable triggered update of IPX
By default, the triggered update feature of IPX is disabled.
7.2.8 Configure Split Horizon of IPX
Split horizon eliminates routing loops by forbidding the switch to send the routing
information out the interface where it is received. In some cases, however, split horizon
must be disabled to ensure the correct transmission of routing information.
Perform the following configuration in VLAN interface view.
Operation
Operation
Huawei Technologies Proprietary
7-11
Chapter 7 IPX Configuration
Command
ipx sap max-reserve-servers length
undo ipx sap max-reserve-servers
Command
ipx update-change-only
undo ipx update-change-only