Huawei Quidway S6500 Series Operation Manual page 275

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
Display
information
7.4 Typical IP Routing Policy Configuration Example
7.4.1 Configuring to Filter the Received Routing Information
I. Networking requirements
Switch A communicates with Switch B, running OSPF protocol.
Import three static routes through enabling the OSPF protocol on the Switch A.
The route filtering rules can be configured on Switch B to make the received three
static routes partially visible and partially shielded. It means that routes in the
network segments 20.0.0.0 and 40.0.0.0 are visible while those in the network
segment 30.0.0.0 are shielded.
II. Networking diagram
static 20.0.0.0/8
30.0.0.0/8
40.0.0.0/8
Figure 7-1 Filtering the received routing information
III. Configuration procedure
Configure Switch A:
# Configure the IP address of VLAN interface.
[Switch A] interface vlan-interface 100
[Switch A-Vlan-interface100] ip address 10.0.0.1 255.0.0.0
[Switch A] interface vlan-interface 200
[Switch A-Vlan-interface200] ip address 12.0.0.1 255.0.0.0
# Configure three static routes.
[Switch A] ip route-static 20.0.0.1 255.0.0.0 12.0.0.2
Operation
the Community-list
Router ID:1.1.1.1
Vlan-interface100
Vlan-interface200
10.0.0.1/8
12.0.0.1/8
Switch A
Huawei Technologies Proprietary
Chapter 7 IP Routing Policy Configuration
display
[ basic-comm-list-number
adv-comm-list-number ]
Router ID:2.2.2.2
Vlan-interface100
10.0.0.2/8
Switch B
7-10
Command
ip community-list
area 0
|