Configure A Port As An Edge Port - Huawei Quidway S6500 Series Operation Manual

Hide thumbs Also See for Quidway S6500 Series:
Table of Contents

Advertisement

Operation Manual - STP
Quidway S6500 Series Ethernet Switches
By default, the max transmission speed on every Ethernet port of the switch is 3.

1.2.10 Configure a Port as an Edge Port

An edge port refers to the port not directly connected to any switch or indirectly
connected to a switch over the connected network.
You can configure a port as an edge port or non-edge port in the following ways.
I. Configure in system view
Perform the following configuration in system view.
Table 1-13 Configure a port as an edge port or a non-edge port
Configure a port as an edge port.
Configure a port as a non-edge port.
Restore the default setting, non-edge
port, of the port.
II. Configure in Ethernet port view
Perform the following configuration in Ethernet port view.
Table 1-14 Configure a port as an edge port or a non-edge port
Configure a port as an edge port.
Configure a port as a non-edge port.
Restore the default setting, non-edge
port, of the port.
You can configure a port as an edge port or a non-edge port with either of the
above-mentioned measures. For more about the commands, refer to the Command
Manual.
After configured as an edge port, the port can fast transit from blocking state to
forwarding state without any delay. In the case that BPDU protection has not been
enabled on the switch, the configured edge port will turn into non-edge port again when
it receives BPDU from other port. In the case that BPDU protection is enabled, the port
will be disabled. The configuration of this parameter takes effect on all the STIs. In other
words, if a port is configured as an EdgedPort or Non- EdgedPort, it is configured the
same on all the STIs.
Operation
Operation
Huawei Technologies Proprietary
1-19
Chapter 1 MSTP Region-configuration
Command
stp interface interface-list edged-port
enable
stp interface interface-list edged-port
disable
undo
stp
interface
edged-port
Command
stp edged-port enable
stp edged-port disable
undo stp edged-port
interface-list

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Release 3000 series

Table of Contents