Huawei Quidway S6500 Series Operation Manual page 153

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
[Switch B] ip route-static 1.1.5.0 255.255.255.0 1.1.3.1
[Switch B] ip route-static 1.1.1.0 255.255.255.0 1.1.3.1
# Configure the static route for Ethernet Switch C
[Switch C] ip route-static 1.1.1.0 255.255.255.0 1.1.2.1
[Switch C] ip route-static 1.1.4.0 255.255.255.0 1.1.3.2
# Configure the default gateway of the Host A to be 1.1.5.1
# Configure the default gateway of the Host B to be 1.1.4.1
# Configure the default gateway of the Host C to be 1.1.1.1
By then, all the hosts or Ethernet Switches in the figure can be interconnected in pairs.
2.5 Static Route Fault Diagnosis and Troubleshooting
Fault: the S6500 Series Ethernet Switch is not configured with the dynamic routing
protocol and both the physical status and the link layer protocol status of the interface is
UP, but the IP packets cannot be forwarded normally.
Troubleshooting: Perform the check according to the following steps.
Use the display ip routing-table protocol static command to view whether the
corresponding static route is correctly configured.
Use the display ip routing-table command to view whether the corresponding
route is valid.
Huawei Technologies Proprietary
2-6
Chapter 2 Static Route Configuration