Pim-Sm Configuration; Enabling Multicast; Enabling Pim-Sm Protocol - Huawei Quidway S6500 Series Operation Manual

Operation Manual - Multicast Protocol
Quidway S6500 Series Ethernet Switches
Table 6-8 Clearing PIM neighbors
Clear PIM neighbors

6.3 PIM-SM Configuration

Basic configuration of PIM-SM include:

Enabling multicast

Enabling PIM-SM protocol

Entering the PIM view
Configuring C-BSR
Configuring C-RP
Configuring static RP
Advanced configuration of PIM-SM include:
Configuring PIM-SM domain boundary
Configuring the interval of Hello messages
Configuring multicast source (group) policy
Configuring the filtering of PIM neighbors
Limiting the number of PIM neighbors of an interface
Configuring RP register policy
Configuring threshold for switching from RPT to SPT
Configuring BSR policy
Configuring C-RP policy
Clearing PIM routing entries
Clearing PIM neighbors
It is noteworthy that at least one router in an entire PIM-SM domain should be
configured with Candidate-RP and Candidate-BSR.
6.3.1 Enabling Multicast
See Chapter 4 Common Multicast Configuration.
6.3.2 Enabling PIM-SM Protocol
This configuration can be effective only after multicast is enabled.
Please perform the following configurations in interface view.
Operation
Huawei Technologies Proprietary
Command
reset pim neighbor { all | { neighbor-address |
interface interface-type interface-number } * }
6-8
Chapter 6 PIM Configuration