Huawei Quidway S6500 Series Operation Manual page 66

Operation Manual - Port
Quidway S6500 Series Ethernet Switches
2) Static LACP aggregation
# Create static LACP aggregation group 1.
[Quidway] link-aggregation group 1 mode static
# Add Ethernet ports Ethernet1/0/1 to Ethernet1/0/3 into aggregation group 1.
[Quidway] interface ethernet1/0/1
[Quidway-Ethernet1/0/1] port link-aggregation group 1
[Quidway-Ethernet1/0/1] interface ethernet1/0/2
[Quidway-Ethernet1/0/2] port link-aggregation group 1
[Quidway-Ethernet1/0/2] interface ethernet1/0/3
[Quidway-Ethernet1/0/3] port link-aggregation group 1
3) Dynamic LACP aggregation
# Enable LACP at Ethernet ports Ethernet1/0/1 to Ethernet1/0/3.
[Quidway] interface ethernet1/0/1
[Quidway-Ethernet1/0/1] lacp enable
[Quidway-Ethernet1/0/1] interface ethernet1/0/2
[Quidway-Ethernet1/0/2] lacp enable
[Quidway-Ethernet1/0/2] interface ethernet1/0/3
[Quidway-Ethernet1/0/3] lacp enable
Only when the three ports are configured with identical basic configuration, rate and
duplex mode, can they be added into a same dynamic aggregation group after LACP is
enabled on them, for load sharing.
Huawei Technologies Proprietary
2-10
Chapter 2 Link Aggregation Configuration