Huawei Quidway S6500 Series Operation Manual page 223

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
find the route to the same destination, the protocol with the higher preference will take
effect.
Perform the following configurations in IS-IS view.
Table 5-33 Configuring the preference of IS-IS protocol
Configure the preference of IS-IS protocol
Restore the default preference of IS-IS protocol
By default, the preference of IS-IS route is 15.
5.2.31 Resetting All the IS-IS Data Structure
When it is necessary to refresh some LSPs immediately, perform the following
configuration in user view.
Table 5-34 Resetting all the IS-IS data structures
Reset the IS-IS data structure
By default, the IS-IS data structure is not cleared.
5.2.32 Resetting the Specified IS-IS Peer
When it is necessary to connect a specified peer again, perform the following
configuration in user view.
Table 5-35 Resetting the specified IS-IS peer
Reset the specified IS-IS peer
By default, the IS-IS peer is not cleared.
Operation
Operation
Operation
Huawei Technologies Proprietary
5-22
Chapter 5 Integrated IS-IS Configuration
Command
preference value
undo preference
Command
reset isis all
Command
reset isis peer system-id