Huawei Quidway S6500 Series Operation Manual page 571

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches
2) Configuring to output information to SNMP NM
Perform the following operation in system view.
Table 4-43 Configuring to output information to SNMP NM
Output information to SNMP NM
Cancel the configuration of outputting
information to SNMP NM
3) Configuring information source on the switch
By this configuration, you can define the information that sent to SNMP NM is
generated by which modules, information type, information level, and so on.
Perform the following operation in system view:
Table 4-44 Defining information source
Define information source
Cancel the configuration of
information source
modu-name specifies the module name; default represents all the modules; level
refers to the severity levels; severity specifies the severity level of information. The
information with the level below it will not be output. channel-number specifies the
channel number and channel-name specifies the channel name.
When defining the information sent to SNMP NM, channel-number or channel-name
must be set to the channel that corresponds to Console direction.
Every channel has been set with a default record, whose module name is default and
the module number is 0xffff0000. However, for different channels, the default record
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
Operation
Operation
Huawei Technologies Proprietary
Chapter 4 System Maintenance and Debugging
info-center
{ channel-number | channel-name }
undo info-center snmp channel
Command
info-center source { modu-name | default }
channel { channel-number | channel-name } [ { log |
trap | debug }* { level severity | state state }* ]
undo info-center source { modu-name | default }
channel { channel-number | channel-name }
4-26
Command
snmp channel