Huawei Quidway S6500 Series Operation Manual page 234

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
Table 6-5 Configuring the state of a peer/peer group
Enable a peer/peer group
disable a peer/peer group
By default, a peer or peer group is enabled.
When exchanging routing information between BGP speakers, the peer group must be
enabled first and then the peer should be added to the enabled peer group.
V. Configuring description of a peer (group)
Description of a peer (group) can be configured to facilitate learning the characteristics
of the peer .
Table 6-6 Configuring description of a peer (group)
Configure description of a peer (group)
Delete description of a peer (group)
By default, no BGP peer (group) description is set.
VI. Configuring timer of peer (group)
The peer timer command is used to configure timers of BGP peer (group), including
the keep-alive message interval and the hold timer. The preference of this command is
higher than the timer command that is used to configure timers for the whole BGP
peers.
Table 6-7 Configuring timer of peer (group)
Configure keep-alive message interval
and hold timer of peer (group)
Restore the default value of keep-alive
message interval and hold timer of a
peer (group)
Operation
Operation
Operation
Huawei Technologies Proprietary
Command
peer { group-name | peer-address } enable
undo peer { group-name | peer-address } enable
peer { peer-address | group-name }
description description-line
undo peer
group-name } description
peer { group-name | peer-address }
timer keep-alive
hold holdtime-interval}
undo peer
peer-address } timer
6-7
Chapter 6 BGP Configuration
Command
{ peer-address
Command
keepalive-interval
{ group-name
|
|