Huawei Quidway S6500 Series Operation Manual page 163

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
Table 3-13 Configuring default cost for the imported route
Configure default cost for the imported route
Restore the default cost of the imported route.
By default, the cost value for the RIP imported route is 1.
3.2.14 Setting the RIP Preference
Each kind of routing protocol has its own preference, by which the routing policy will
select the optimal one from the routes of different protocols. The greater the preference
value is, the lower the preference becomes. The preference of RIP can be set
manually.
Perform the following configurations in RIP view.
Table 3-14 Setting the RIP Preference
Set the RIP Preference
Restore the default value of RIP preference
By default, the preference of RIP is 100.
3.2.15 Setting Additional Routing Metric
Additional routing metric is the input or output routing metric added to an RIP route. It
does not change the metric value of the route in the routing table, but adds a specified
metric value when the interface receives or sends a route.
Perform the following configuration in Interface view:
Table 3-15 Setting additional routing metric
Set the additional routing metric of the route
when the interface receives an RIP packet
Disable the additional routing metric of the
route when the interface receives an RIP
packet
Operation
Operation
Operation
Huawei Technologies Proprietary
3-10
Chapter 3 RIP Configuration
Command
default cost value
undo default cost
Command
preference value
undo preference
Command
rip metricin value
undo rip metricin