Huawei Quidway S6500 Series Operation Manual page 225

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
5.4 Typical Integrated IS-IS Configuration Example
I. Networking requirement
As is shown in the following figure, Switches A, B, C and D belong to the same
autonomous system. The IS-IS routing protocol is run in these four switches so as to
implement route interconnection. In network design, switches A, B, C and D belong to
the same area.
II. Networking diagram
Switch A
Switch D
Figure 5-3 IS-IS configuration example
III. Configuration procedure
# Configure Switch A
[Switch A] isis
[Switch A-isis] network-entity 86.0001.0000.0000.0005.00
[Switch A] interface vlan-interface 100
[Switch A-Vlan-interface100] ip address 100.10.0.1 255.255.255.0
[Switch A-Vlan-interface100] isis enable
[Switch A] interface vlan-interface 101
[Switch A-Vlan-interface101] ip address 100.0.0.1 255.255.255.0
[Switch A-Vlan-interface101] isis enable
Vlan-interface 101
100.0.0.1/24
Vlan-interface 100
100.10.0.1/24
Vlan-interface 102
100.20.0.1/24
Vlan-interface 102
100.20.0.2/24
Vlan-interface 100
100.30.0.1/24
Huawei Technologies Proprietary
Chapter 5 Integrated IS-IS Configuration
Vlan-interface 102
200.0.0.1/24
Vlan-interface 100
100.10.0.2/24
Vlan-interface 101
200.10.0.1/24
Vlan-interface 101
200.10.0.2/24
Vlan-interface 100
200.20.0.1/24
5-24
Switch B
Switch C