Huawei Quidway S6500 Series Operation Manual page 562

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches
2) Configuring to output information to console terminal
Perform the following operation in system view.
Table 4-25 Configuring to output information to console terminal
Output information to Console
Cancel
outputting information to Console
3) Configuring information source on the switch
By this configuration, you can define the information that sent to console terminal is
generated by which modules, information type, information level, and so on.
Perform the following operation in system view:
Table 4-26 Defining information source
Operation
Define
source
Cancel
configuration
information source
modu-name specifies the module name; default represents all the modules; level
refers to the severity levels; severity specifies the severity level of information. The
information with the level below it will not be output. channel-number specifies the
channel number and channel-name specifies the channel name.
When defining the information sent to the console terminal, channel-number or
channel-name must be set to the channel that corresponds to Console direction.
Every channel has been set with a default record, whose module name is default and
the module number is 0xffff0000. However, for different channels, the default record
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
Operation
the configuration
info-center source { modu-name | default } channel
information
{ channel-number | channel-name } [ { log | trap | debug }*
{ level severity | state state }* ]
the
undo info-center source { modu-name | default } channel
of
{ channel-number | channel-name }
Huawei Technologies Proprietary
Chapter 4 System Maintenance and Debugging
info-center
channel{ channel-number | channel-name }
of
undo info-center console channel
Command
4-17
Command
console