Enable The Timing Reboot Function; Designate The App Adopted When Booting The Ethernet Switch Next Time - Huawei Quidway S6500 Series Operation Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches

3.2.3 Enable the Timing Reboot Function

After enable the timing reboot function on the switch, the switch will be rebooted on the
specified time.
Perform the following configuration in user view, and display schedule reboot
command can be performed in any view.
Table 3-3 Reboot the switch
Enable the timing reboot function of the
switch, and set specified time and date
Enable the timing reboot function of the
switch, and set waiting time
Cancel the parameter configuration of
timing reboot function of the switch
Check the parameter configuration of the
reboot terminal service of the current
switch
Note:
The precision of switch timer is 1 minute. The switch will reboot in one minute when
time comes to the specified rebooting point.
3.2.4 Designate the APP Adopted when Booting the Ethernet Switch Next
Time
In the case that there are several APPs in the Flash Memory, you can use this
command to designate the APP adopted when booting the Ethernet switch next time.
Perform the following configuration in user view.
Table 3-4 Designate the APP adopted when booting the Ethernet switch next time
Designate the APP adopted when
booting the Ethernet switch next time
You can specify two boot files at the same time, one is the primary boot file, the other is
the backup. When the switch boots, the process is as follows:
1) The switch first selects the primary boot file.
2) If the switch cannot be booted by the primary boot file, it selects the backup file.
Operation
Operation
Huawei Technologies Proprietary
3-2
Chapter 3 Device management
Command
schedule reboot
[ yyyy/mm/dd ]
schedule reboot delay { hhh:mm |
mmm }
undo schedule reboot
display schedule reboot
Command
boot boot-loader { primary | backup }
file-url [ slot slot-num ]
at hh:mm