Huawei Quidway S6500 Series Operation Manual page 65

Operation Manual - Port
Quidway S6500 Series Ethernet Switches
Disable/enable debugging
link aggregation events
2.4 Link Aggregation Configuration Example
I. Networking Requirement
Switch A connects switch B with three aggregation ports, numbered as Ethernet1/0/1 to
Ethernet1/0/3, so that incoming/outgoing load can be balanced among the member
ports.
II. Networking diagram
Link aggregation
Figure 2-1 Networking for link aggregation
III. Configuration procedure
The following only lists the configuration for switch A, and that on switch B is similar.
1) Manual link aggregation
# Create manual aggregation group 1.
[Quidway] link-aggregation group 1 mode manual
# Add Ethernet ports Ethernet1/0/1 to Ethernet1/0/3 into aggregation group 1.
[Quidway] interface ethernet1/0/1
[Quidway-Ethernet1/0/1] port link-aggregation group 1
[Quidway-Ethernet1/0/1] interface ethernet1/0/2
[Quidway-Ethernet1/0/2] port link-aggregation group 1
[Quidway-Ethernet1/0/2] interface ethernet1/0/3
[Quidway-Ethernet1/0/3] port link-aggregation group 1
Operation
[ undo ] debugging link-aggregation event
Switch A
Switch B
Huawei Technologies Proprietary
Chapter 2 Link Aggregation Configuration
Command
2-9