Huawei Quidway S6500 Series Operation Manual page 62

Operation Manual - Port
Quidway S6500 Series Ethernet Switches
During creating an aggregation group, if it already exists in the system but contains no
member port, it changes to the new type; if it already exists in the system and contains
member ports, then you can only change a dynamic or static LACP aggregation group
to a manual one, or a dynamic LACP aggregation group to a static one. In the former
case, LACP shall be disabled at the member ports automatically, while in the latter case,
LACP shall remain enabled.
2.2.3 Add/Delete Ethernet Port into/from Aggregation Group
You can add/delete ports into/from a manual or static LACP aggregation group, but
member port adding or deleting for a dynamic LACP aggregation group is implemented
by the system.
Perform the following configuration in corresponding view.
Table 2-3 Add/delete Ethernet port into/from aggregation group
Add an
aggregation group (Ethernet port view)
Delete an Ethernet port from the
aggregation port (Ethernet port view)
Aggregate Ethernet ports (System view)
Note that:
You cannot enable LACP at the mirrored port, port with static MAC address
configured, port with static ARP configured, port with 802.1x enabled.
You must delete the aggregation group, instead of the port, if the manual or static
LACP aggregation group contains only one port.
2.2.4 Set/Delete Aggregation Group Descriptor
Perform the following configuration in system view.
Table 2-4 Set/delete aggregation group descriptor
Set aggregation group descriptor
Delete aggregation group descriptor
Operation
Ethernet port into
Operation
Huawei Technologies Proprietary
2-6
Chapter 2 Link Aggregation Configuration
Command
the
port link-aggregation group agg-id
undo port link-aggregation group
link-aggregation interface_name1 to
interface_name2 [ both ]
Command
link-aggregation
description alname
undo link-aggregation group agg-id
description
group agg-id