Configuring C-Rp Policy; Clearing Pim Routing Entries; Clearing Pim Neigthbore; Displaying And Debugging Pim Configuration - Huawei Quidway S6500 Series Operation Manual

Operation Manual - Multicast Protocol
Quidway S6500 Series Ethernet Switches

6.3.14 Configuring C-RP Policy

To prevent C-RP spoofing, C-RP policy can be configured to specify the range of valid
C-RPs and of groups served by each C-RP.
Perform the following configurations in PIM view.
Table 6-16 Configuring C-RP policy
Configure C-RP policy
Remove C-RP policy
For the details of the crp-policy command, refer to Command Manual.

6.3.15 Clearing PIM Routing Entries

See 6.2.8 Clearing PIM Routing Entries.

6.3.16 Clearing PIM Neigthbore

See 6.2.9 Clearing PIM Neighbors.

6.4 Displaying and Debugging PIM Configuration

After the above configuration, you can use the display commands in any view to display
the running information of PIM, and to verify the effect of the configuration.
Execute the debugging commands in user view for the debugging of PIM.
Table 6-17 Displaying and debugging PIM configuration
Display PIM multicast routing
table
Display
information
Display
information
Display BSR information
Display RP information
Operation
Operation
PIM interface
PIM neighbors
Huawei Technologies Proprietary
crp-policy acl-number
undo crp-policy
Command
display pim routing-table [ { { *g [ group-address
[ mask { mask-length | mask } ] ] | **rp [ rp-address
[ mask { mask-length | mask } ] ] } |
{ group-address [ mask { mask-length | mask } ] |
source-address [ mask { mask-length | mask } ] }
}
* | incoming-interface
interface-num | interface-name
{ dense-mode | sparse-mode } ] *
display pim interface
interface-number ]
display pim neighbor [ interface interface-type
interface-number ]
display pim bsr-info
display pim rp-info [ group-address ]
6-13
Chapter 6 PIM Configuration
Command
{ interface-type
| null }
[ interface-type
|