Huawei Quidway S6500 Series Operation Manual page 565

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches
Table 4-31 Defining information source
Define information source
Cancel the configuration of
information source
modu-name specifies the module name; default represents all the modules; level
refers to the severity levels; severity specifies the severity level of information. The
information with the level below it will not be output. channel-number specifies the
channel number and channel-name specifies the channel name.
When defining the information sent to Telnet terminal or dumb terminal,
channel-number or channel-name must be set to the channel that corresponds to
Console direction.
Every channel has been set with a default record, whose module name is default and
the module number is 0xffff0000. However, for different channels, the default record
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
Note:
When there are more than one Telnet users or monitor users at the same time, some
configuration parameters should be shared among the users, such as module-based
filtering settings and severity threshold. When a user modifies these settings, it will be
reflected on other clients.
Note:
If you want to view the debugging information of some modules on the switch, you must
select debugging as the information type when configuring information source,
meantime using the debugging command to turn on the debugging switch of those
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in system view:
Operation
Huawei Technologies Proprietary
Chapter 4 System Maintenance and Debugging
Command
info-center source { modu-name | default }
channel { channel-number | channel-name } [ { log |
trap | debug }* { level severity | state state }* ]
undo info-center source { modu-name | default }
channel { channel-number | channel-name }
4-20