Set The Source Address Of Trap; Add/Delete A User To/From An Snmp Group - Huawei Quidway S6500 Series Operation Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches
Table 5-10 Set/Delete an SNMP Group
Setting an SNMP group
Deleting an SNMP group

5.3.10 Set the Source Address of Trap

You can use the following commands to set or remove the source address of the trap.
Perform the following configuration in system view.
Table 5-11 Set the source address of trap
Set the Source Address of Trap
Remove the source address of trap

5.3.11 Add/Delete a User to/from an SNMP Group

You can use the following commands to add or delete a user to/from an SNMP group.
Perform the following configuration in system view.
Table 5-12 Add/Delete a user to/from an SNMP group
Operation
Add a user to
an
group.
Delete a user
from an SNMP
group.
Operation
snmp-agent group { v1 | v2c } group-name
[ read-view read-view ] [ write-view write-view ]
[ notify-view notify-view ] [ acl acl-list ]
snmp-agent group v3 group-name [ authentication |
privacy ] [ read-view read-view ] [ write-view
write-view ] [notify-view notify-view ] [ acl acl-list ]
undo snmp-agent group { v1 | v2c } group-name
undo
[ authentication | privacy ]
Operation
snmp-agent usm-user { v1 | v2c } username groupname [ acl
acl-list ]
SNMP
snmp-agent
[ authentication-mode
[ privacy-mode { des56 privpassstring } ] ] [ acl acl-list ]
undo snmp-agent usm-user { v1 | v2c } username groupname
undo snmp-agent usm-user v3 username groupname { local |
engineid engine-id }
Huawei Technologies Proprietary
Command
snmp-agent group
snmp-agent
interface-name interface-num
undo snmp-agent trap source
Command
usm-user v3
{ md5
5-7
Chapter 5 SNMP Configuration
v3 group-name
Command
trap source
username groupname
| sha } authpassstring