Huawei Quidway S6500 Series Operation Manual page 80

Operation Manual - VLAN
Quidway S6500 Series Ethernet Switches
Table 2-1 Set GARP timer
Set GARP Hold timer, Join timer and
Leave timer
Set GARP LeaveAll timer
Restore the default GARP Hold timer,
Join timer and Leave timer settings
Restore the default GARP LeaveAll
timer settings.
The range is according to the following rule:
the value of Join timer should be no less than the doubled value of Hold timer,
the value of Leave timer should be greater than the doubled value of Join timer
and smaller than the Leaveall timer value,
the minimal value of Join timer is 10 centiseconds.
By default, Hold timer is 10 centiseconds, Join timer is 20 centiseconds, Leave
timer is 60 centiseconds.
Value range of each timer changes with value range of another timer. If the value of the
timer you want to set is out of the current range, you can change the related timer value.
The lower limit of the Hold timer value is 10 centiseconds, and the upper limit can
be changed by changing the value of the Join timer;
The lower limit of the Join timer changes with the Hold timer value, and the upper
limit can be changed by changing the value of the Leave timer;
The lower limit of the Leave timer changes with the Join timer value, and the upper
limit can be changed by changing the value of the LeaveAll timer;
The lower limit of the LeaveAll timer changes with the Leave timer value, and the
upper limit is 32765 centiseconds.
2.1.3 Display and Debug GARP
After the above configuration, execute display command in any view to display the
running of GARP configuration, and to verify the effect of the configuration. Execute
reset command in user view to reset the configuration of GARP. Execute debugging
command in user view to debug the configuration of GARP.
Operation
Huawei Technologies Proprietary
2-3
Chapter 2 GARP/GVRP Configuration
Command
garp timer { hold | join | leave }
timer_value
garp timer leaveall timer_value
undo garp timer { hold | join | leave }
undo garp timer leaveall