Huawei Quidway S6500 Series Operation Manual page 130

Operation Manual - Network Protocol
Quidway S6500 Series Ethernet Switches
7.4 IPX Configuration Example
I. Networking requirements
Through an IPX network, Switch A with the node address of 00e0-fc01-0000 is
connected to Switch B with the node address of 00e0-fc01-0001.
There is a server installed with NetWare 4.1 and assigned the network number of 2. On
the server, the packet encapsulation format is set to Ethernet_II. The client is a PC with
the network number of 3 and the packet encapsulation format of SNAP. The client
accesses the file and directory services provided by the server through the IPX network.
The node address of the server is 0000-0c91-f61f.
II. Networking diagram
Switch A Switch A
VLAN interface 2 VLAN interface 2
2.00e0-fc01-0000 2.00e0-fc01-0000
Server Server
Figure 7-1 IPX network topology
III. Configuration procedure
1) Configure Switch A
# Enable IPX.
[Quidway] ipx enable
# Assign the network number 2 to VLAN interface 2 to enable IPX on the interface.
[Quidway] interface vlan-interface 2
[Quidway-Vlan-interface2] ipx network 2
# Set the IPX packet encapsulation format to Ethernet_II on VLAN interface 2.
[Quidway-Vlan-interface2] ipx encapsulation ethernet-2
[Quidway-Vlan-interface2] quit
# Assign the network number 1000 to VLAN interface 1 to enable IPX on the interface.
[Quidway] interface vlan-interface 1
[Quidway-Vlan-interface1] ipx network 1000
VLAN intefae 1 VLAN intefae 1
IPX IPX
1000.00e0-fc01-0000 1000.00e0-fc01-0000
Huawei Technologies Proprietary
VLAN inte VLAN inte rface 1 rface 1
1000.00e0-fc01-000 1000.00e0-fc01-000 1 1
VLAN i VLAN i nterface 2 nterface 2
3.00e 3.00e 0-fc01-0001 0-fc01-0001
7-14
Chapter 7 IPX Configuration
Switch B Switch B
Client Client