Typical Ntp Configuration Example - Huawei Quidway S6500 Series Operation Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches
Table 7-16 NTP display and debugging
Display the status of NTP service
Display the status of sessions maintained by
NTP service
Display the brief information about every NTP
time server on the way from the local
equipment to the reference clock source.
Enable NTP debugging

7.4 Typical NTP Configuration Example

I. Configure NTP server
1) Network requirements
On Quidway1, set local clock as the NTP master clock at stratum 2. On Quidway2,
configure Quidway1 as the time server in server mode and set the local equipment as in
client mode.
2) Networking diagram
Quidway1
Quidway2
Figure 7-2 Typical NTP configuration networking diagram
3) Configuration procedure
Configure Ethernet Switch Quidway1:
# Enter system view.
<Quidway1> system-view
# Set the local clock as the NTP master clock at stratum 2.
[Quidway1] ntp-service refclock-master 2
Configure Ethernet Switch Quidway2:
Operation
Vlan-interface2:
1.0.1.11
1.0.1.2
Quidway0
Vlan-interface2:
1.0.1.12
......
Huawei Technologies Proprietary
display ntp-service status
display
[ verbose ]
display ntp-service trace
debugging ntp-service
Vlan-interface2:
3.0.1.31
Vlan-interface2:
3.0.1.2
3.0.1.32
Vlan-interface2:
3.0.1.33
7-11
Chapter 7 NTP Configuration
Command
ntp-service sessions
Quidway3
Quidway4
Quidway5