Huawei Quidway S6500 Series Operation Manual page 563

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches
Note:
If you want to view the debugging information of some modules on the switch, you must
select debugging as the information type when configuring information source,
meantime using the debugging command to turn on the debugging switch of those
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in system view:
Table 4-27 Configuring the output format of time-stamp
Configure the output format of the
time-stamp
Output time-stamp is disabled
4) Enable terminal display function
To view the output information at the console terminal, you must first enable the
corresponding log, debugging and trap information functions at the switch.
For example, if you have set the log information as the information sent to the console
terminal, now you need to use the terminal logging command to enable the terminal
display function of log information on the switch, then you can view the information at
the console terminal.
Perform the following operation in user view:
Table 4-28 Enabling terminal display function
Enable terminal display function of debugging
information
Disable terminal display function of debugging
information
Enable terminal display function of log information
Disable terminal display function of log information
Enable terminal display function of trap information
Disable terminal display function of trap information
Operation
Operation
Huawei Technologies Proprietary
4-18
Chapter 4 System Maintenance and Debugging
Command
info-center timestamp
debugging } { boot | date | none }
undo info-center timestamp { log | trap |
debugging }
terminal debugging
undo terminal debugging
terminal logging
undo terminal logging
terminal trapping
undo terminal trapping
{ log | trap |
Command